AM4376 configuration for usage with the DP83867 1Gb ethernet phy

Jay Jang

Other Parts Discussed in Thread: AM4376

Hello,

The start kit for the AM4376 uses the Microchip part (KSX9301)..
Can you please provide steps to configure the device to work with the TI DP83867?

Please provide background on any history on these devices being paired together, and point out any 'gotchas' that the team has run across.

Thank you,

Jay

over 9 years ago

0 Jay Jang over 9 years ago

TI__Intellectual 915 points

Correction: Micrel KSZ9031RNX on the starter kit

0 Biser Gatchev-XID over 9 years ago in reply to Jay Jang

TI__Guru**** 393215 points

Hi,

I will ask the software team to comment.

0 Yordan Kovachev over 9 years ago in reply to Jay Jang

TI__Guru**** 161600 points

Hi,

Which linux SDK are you using?

You may need to add the DP83867 driver into your kernel sources & rebuild. Check if dp83867.c driver is available in drivers/net/phy/ in your linux sources. It should be available in kernel 4.1.13, you'll just have to build it in your kernel through Menuconfig.

Best Regards,
Yordan

Processors

Processors forum

AM4376 configuration for usage with the DP83867 1Gb ethernet phy