USB configuration of AM335X

Mohasinali Attar

Intellectual 630 points

How to configure USB of AM335X so that it acts only in peripheral mode? I want to connect the starter kit to a host PC.

over 9 years ago

0 Biser Gatchev-XID over 9 years ago

TI__Guru**** 393215 points

This can be done through the MicroAB USB connector J3. You will beed to configure USB0 in Device mode: processors.wiki.ti.com/.../Linux_Core_MUSB_User's_Guide

0 Mohasinali Attar over 9 years ago in reply to Biser Gatchev-XID

Intellectual 630 points

If I want to use VxWorks then the procedure would be same?

0 Biser Gatchev-XID over 9 years ago in reply to Mohasinali Attar

TI__Guru**** 393215 points

This forum supports only the Linux SDK provided by TI. Vxworks is a third-party software, which is not supported by TI, so I cannot say how software configuration is done there.

Processors

Processors forum

USB configuration of AM335X