AM5728 Pin Mux Tool GMAC_SW0 RMII & MII swapped

1541703

I went to setup GMAC_SW0 in the Pin Mux tool as an RMII. However it appears that the RMII setting and MII setting are swapped. The RMII setting had the 4 TX & 4 RX data signals and separate RX & TX clocks, while the MII setting has the 2 TX & 2 RX data signals. Am I looking at this wrong.

over 9 years ago

0 Biser Gatchev-XID over 9 years ago

TI__Guru**** 393215 points

Please post your pinmux file.

0 Alex Bashkov over 9 years ago

TI__Genius 13425 points

I am shooting blind here, but I think this is the well known bug with wrongly associated RMII/MII use case selection options to actuall RMII/MII signals. But please, as Biser suggested, post your .pinmux config file for us to confirm it's same issue (which is already fixed by the way and will appear correct in the upcoming tool version)

Thanks

Processors

Processors forum

AM5728 Pin Mux Tool GMAC_SW0 RMII & MII swapped