Adding Subnet to Packet Accelerator

serdar kocer

Intellectual 280 points

Other Parts Discussed in Thread: AM5K2E04

Hello,

As you know, a IP address could be added to PA but I need to add IP Subnet to Packet Accelerator.

Could you tell me it is possible or not? If It is possible, How would I apply this action to PA?

Thank for your help

Serdar

over 9 years ago

0 Titusrathinaraj Stalin over 9 years ago

TI__Guru** 116100 points

Dear Serdar,
I am not sure so, will ask internal team to reply for this particular question.
Thanks for the patience.

0 serdar kocer over 9 years ago in reply to Titusrathinaraj Stalin

Intellectual 280 points

Thanks you Titus,

Waiting for your reply.

Serdar

0 lding over 9 years ago in reply to serdar kocer

TI__Guru* 95265 points

Serdar,

From PA user guide: www.ti.com/.../sprugs4a.pdf

2.5 L3 Classify Engine Architecture, the LUT table consists of 64 entries, you need to add the IP addresses (under the same subnet) one by one.

Regards, Eric

0 serdar kocer over 9 years ago in reply to lding

Intellectual 280 points

Hello Eric,

Thanks your answer that is about PA.Also I have been using AM5K2E04 that contains PA2.

What about the PA2 (AM5K2E04 )? Could I add IP subnet its LUT table?

Thank you.

Serdar

Processors

Processors forum

Adding Subnet to Packet Accelerator