run omapl138 lcdk code on c6748 lcdk

Hi Titus,

I am developing a simple audio loopback code based on the code on this book : .  

I run perfectly fine on CCS debugger. I can hear the audio loopback using a headphone.

The steps are :

1. flash the omapl138 lcdk using a special (debugging bootloader ??) . Here is the link for the file :  (Reflashing the LCDK. Instructions. Needed files in a zip archive.)Reflashing LCDK for winDSK8.zip

2. debug the following code as usual in CCS 6.  And  the audio loop back  worked fine. 

5287.in-out.zip

My question is if I want to make a standaone system on c6748 OR omapl138 LCDK, what steps should I do ?

I have tried gpio blinking on both c6748 and omap llcdk and they both can be booted and run perfectly.

But, not on the audio loopback code ...While I know for sure the audio loopback code is fine, as I run perfectly on CCS debug mode.

So, there is something special on the kernal that need to be flashed as on point 1 above.

Couldyou please help me solve this issue...

Thank you very much for your attention.

Hi siauhwa ong,
My question is if I want to make a standaone system on c6748 OR omapl138 LCDK, what steps should I do ?
Please refer the below link,
processors.wiki.ti.com/.../OMAPL138_StarterWare_Booting_And_Flashing

If its worked with debug mode and not worked in boot mode then some configuration in AIS setting is missing.
Have you set the bootloader Entry point properly.
Using this entry point only bootloader will give the control to the application.

Sounds good.
Thanks for the update.