hello,
Today when I was trying to download program to the K2E (chip model is 66AK2E05),but the computer doesn't connect K2E succesfully,as the following picture,normlly,when connected succesfully,the LED D7 and D8 is lighting,but now only D7 is lighting,what's wrong with my K2E?how can I fix it?Thank you!
now I will describe the steps to load the image.
1st,I set up configuration switch as shown for No Boot mode
2nd,connnect the USB mini-B cable to XDS200.earlier when I do this step,the computer will remind me,but now nothing happened.
Hi user425211123,
Follow the below steps to connect the K2E EVM with the CCS through on-board emulator.
1. Connect the USB cable between the k2E EVM ( J3) and the host PC where you run the CCS. Go to Device manager and check whether it detects the onboard xDS2xx Emulator.
2. Create a target configuration file for K2E in CCS.
CCS-->View target configuration --> Right click on User defined --> New target configuration --> select the appropriate Board and the emulator. Open the target configuration file, go to advanced --> click C66x --> locate the gel file, evmk2e.gel
3. Do test connection and observe the messages.
