• State Resolved
  • Locked Locked
  • Replies 6 replies
  • Subscribers 98 subscribers
  • Views 2577 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

PMIC Reset During Reboot

chandan kumar
Intellectual 440 points

Other Parts Discussed in Thread: AM5728, TPS659037

Hi,

We have designed a PCB by taking AM5728 EVM as reference.

When we initiate the Reboot Command,  please let us know will the power cycle to the AM5728  gets reseted(i:e will the PMIC gets reseted).??

Thanks,

chandan

  • 0
    TI__Guru**** 161600 points
    Hi,

    If you've followed the AM5728 EVM reference desing, then you should have the RESETOUTN connected to PMIC NRESWARM pin. In that case the reboot command from linux command line indicates a Global Warm reset to the system (see 3.5.6.22 Global Warm Reset Sequence in TRM). Then the NRESWARM is asserted to the PMIC and the PMIC executes the OFF2ACT sequence.

    Best Regards,
    Yordan
  • 0 in reply to Yordan Kovachev
    Intellectual 440 points

    Hi Yordan ,

    We have followed the AM5728 reference design and the reset outn pin is connected to the PMIC NRESWARM pin .

    When the reboot command is executed the PMIC NRESWARM pin is getting low but the OFF2ACT Sequence is not affecting the change of power state for any of the SMPS & LDO 's(i:e the power rails of MPU,CORE,DDR,DSP etc will never be toggled or changed) .

    In  TPS659037 User's Guide to Power AM572x and AM571x" doc with the reference of Figure 12 it is stated that

    "Figure 12 shows the warm reset sequence of TPS6590376ZWSR in the case that all resources are turned off. If any resource is on when NRESWARM is asserted, the resource remains on.


    Since during the execution of reboot command all the SMPS & LDO are in ON condition ,and even after the OFF2ACT sequence is  initiated the power states of the SMPS and LDO will remains unchanged  as it is in its ON condition during the execution of REBOOT command .

    So please let me know whether by any means i can reset the AM5728 core power rails once the reboot command is executed.

    Thanks.

    chandan

  • 0 in reply to chandan kumar
    Intellectual 440 points

    Hi ,

    I request you to please reply for the above issue.

    Also please let us know how can i initiate the cold reset for my core using software. We tried making SW_RST pin high using i2cset commands but it didnt work.Please let us know is any any dependencies for triggering the cold reset ?

    Thanks,

    chandan

  • 0 in reply to chandan kumar
    Intellectual 440 points
    Hi,

    A little correction.Its SW_RST bit and not SW_RST pin

    Thanks,
    chandan
  • 0 in reply to chandan kumar
    TI__Guru**** 161600 points
    Hi Chandan,

    Have you tried programming the SMPSx_CTRL[1:0]MODE_ACTIVE registers?

    Best Regards,
    Yordan
  • 0 in reply to Yordan Kovachev
    Intellectual 440 points
    Hi Yordan ,

    In SMPSX_CTRL[1:0] MODE_ACTIVE registers what should be the mode that needs to be programmed such that it supports for the cold reset ?


    Thanks,
    chandan