Flashing DM368 using NAND Writer utiliies ????

jhseos

Prodigy 30 points

If USB Clock(12Mhz) and Videod Clock(74.25Mhz) is required, then 36Mhz input crystal should be used.

NAND Programmer operates normally in 24Mhz or 27Mhz input crystal.

But Load the NANDEraser_DM36x.out is error in 36Mhz crystal input.

e.g) Data verification failed at address 0x8E000000. please verify target memory and memory map.

Are you succeed in 36Mhz?

Please, Tell me how to Program in 36Mhz.

over 15 years ago

0 Jeff Hayes over 15 years ago

TI__Expert 6850 points

jhseos,

Please see section 3.3.6 of the DM368 Datasheet for details on oscillator frequencies and PLL settings to satisfy particular requirements for the 3 oscillator frequencies that DM368 supports.

0 chao over 13 years ago

Prodigy 55 points

Hi , jhseos! Have you solved the problem? I met the same error, I try a lot, but I havn't solved it.

Processors

Processors forum

Flashing DM368 using NAND Writer utiliies ????