Starterware/TMS320C6748: ESTOP0 Instruction is there or not

Ramachandra Parlapalli

Expert 1800 points

Part Number: TMS320C6748

Tool/software: Starterware

Hi,

I am using TMS320C6748 processor in that ESTOP0 instructions is there or not? or any different will be there?

Previously i am used asm(" ESTOP0");

over 8 years ago

0 Lalindra Jayatilleke over 8 years ago

TI__Mastermind 30365 points

Moving this thread to the C6748 Single Core DSP Forum.

0 Rahul Prabhu over 8 years ago

TI__Guru** 116170 points

ESTOP0 command is a C2000 assembly instruction which is not avilable in C6000 CPU instruction set. you can use IDLE on C674x DSP which is a Multicycle NOP With No Termination Until Interrupt.

Regards,
Rahul

0 Ramachandra Parlapalli over 8 years ago in reply to Rahul Prabhu

Expert 1800 points

Means i will use {asm(" IDLE"); } instead {asm(" ESTOP0");}

0 Rahul Prabhu over 8 years ago in reply to Ramachandra Parlapalli

TI__Guru** 116170 points

Yes, this should work.

To add a infinite wait, you can use

for(;;) { asm ("nop") ; }

Regards,
Rahul

Processors

Processors forum

Starterware/TMS320C6748: ESTOP0 Instruction is there or not