RTOS/EVMK2H: GPIO event ID is not allowed in EVMK2H

k.s shin

Expert 2115 points

Part Number: EVMK2H

Tool/software: TI-RTOS

Hi.

I use PDK 4.0.4 for EVMK2H.

I have to receive interrupts from GPIOs using Hwi Event.

I registered Hwi Event ID is 134 but build is not success.

error message is "ti.sysbios.family.c64p.Hwi ti.sysbios.family.c64p.Hwi.Instance#0: eventId (134) must be less than 128"

I attached .cfg file. plz check this file.

Regards

Shin.

5G_HUB_pcie.cfg

over 8 years ago

0 Cvetolin Shulev-XID over 8 years ago

TI__Guru 65405 points

Hi Shin,

I've forwarded this to the TI-RTOS experts. Their feedback should be posted here.

BR
Tsvetolin Shulev

0 Rahul Prabhu over 8 years ago

TI__Guru** 116170 points

Please refer to table 6-22 in the datasheet to find the GPIO event ID. I looked it up and it seems to be 106 (GPIO_INTN).

Also, if you are using PDK then there is GPIO LLD provided, which configures the event ID correctly (Refer GPIO_soc.c file for K2H) in GPIO LLD.

Regards,
Rahul

0 k.s shin over 8 years ago in reply to Rahul Prabhu

Expert 2115 points

hi

How to know where pin sent interrupt??

Regards.

Processors

Processors forum

RTOS/EVMK2H: GPIO event ID is not allowed in EVMK2H