Linux/DRA722: The evm boad for UART-boot support

Jack user

Part Number: DRA722

Tool/software: Linux

Hi,

I am debugging the EVM board of booting over UART,

when I follow the steps below to step 4 ,there was not show the output "VA!" appear on teraTerm window.How can i solve this problem?

----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

over 8 years ago

0 Dwarakesh Radhakrishnan over 8 years ago

Guru 13660 points

Hi,

What is the software package being used ? Can you elaborate more ?

0 Jack user over 8 years ago in reply to Dwarakesh Radhakrishnan

Expert 1080 points

Ok , I have solved this problem,I don't set SW5.5 = OFF for UART3 support.
thank you ~

0 Jack user over 8 years ago in reply to Dwarakesh Radhakrishnan

Expert 1080 points

ok,something was wrong,When I completed through the serial upgrade after the implementation of the above steps again appeared above can not print "VA!". I'm use ti-glsdk_dra7xx-evm_7_04_00_03 software package .why can't upgrade again?

Processors

Processors forum

Linux/DRA722: The evm boad for UART-boot support