Loading .out file through command line(not CCS).

Oren Lavi

Other Parts Discussed in Thread: OMAPL138

Hello

I am searching for a tool/software that will let me load the program to the RAM. I don't want to do it through Code composer.

I need a stand alone tool with commands interface.

Best tool is command line. I have read about Loadti, but i didn't find it...

Please advice.

Thanks

over 8 years ago

0 Cvetolin Shulev-XID over 8 years ago

TI__Guru 65405 points

Hi Oren,

I've forwarded this to the OMAP-L13x software experts. Their feedback should be posted here.

BR
Tsvetolin Shulev

0 Rahul Prabhu over 8 years ago

TI__Guru** 116770 points

Oren,

You are right if the intent is to not use the GUI but to only load out using an emulator connection using command line, then you can use loadTI.
processors.wiki.ti.com/.../Loadti

LoadTI is part of the Code composer studio v7 installation
C:\ti\ccsv7\ccs_base\scripting\examples\loadti

The other option, would be to convert your application image into a UART bootable image so it can be loaded using serial loader as explained here:
processors.wiki.ti.com/.../Serial_Boot_and_Flash_Loading_Utility

If you provide the detail if you are using OMAPL137/C6747 or OMAPL138/C6748, I can provide the link to download this utility.

Regards,
Rahul

0 Oren Lavi over 8 years ago in reply to Rahul Prabhu

Prodigy 40 points

Hi

I have succeeded to load the .out file.
I want to use Loadti tool on a computer without Code composer, what do i need to install?
Can i copy or install only specific parts from the Code composer in order to use this tool?

Thanks

Processors

Processors forum

Loading .out file through command line(not CCS).