AM5728: Clock Tree tool question

Michi Yama

Part Number: AM5728

Hi,

I have one question regarding Clock tree tool of AM5728.

The below is screen shot of CTT(version is 1.0.0.2).

I would like to close the switch of L3_INIT_960M_GFCLK that is marked by the blue circle. The status of DPLL_CLKDCOLDO can confirm by CM_CLKDCOLDO_DPLL_USB register.

But I don't know how to close this switch. What register should I configure?

Please advise me.

Best regards,

Michi

over 8 years ago

0 Biser Gatchev-XID over 8 years ago

TI__Guru**** 393215 points

The CTT team have been notified. They will respond here.

0 Yordan Kovachev over 8 years ago

TI__Guru**** 161600 points

Hi,

I'm looking into this.

Best Regards,
Yordan

0 Yordan Kovachev over 8 years ago

TI__Guru**** 161600 points

There are no registers, you need to enable the module that uses this clock. In your particular case, go to USB1 or USB2 and click on Auto Mode in the Controller view on the right side of the CTT window.

Best Regards,
Yordan

Processors

Processors forum

AM5728: Clock Tree tool question