AM4376: Power-up sequence questions

Robert Noe

Part Number: AM4376

I was wondering what would happen if we don't follow the power-up sequence in AM437x processors? Could it damage the device?

And is there a limit to slew rate? In datasheet there is a mention of minimum slew but nothing about a maximum, but I think there should be maximum slew.

Regards,

Robert

over 8 years ago

0 Biser Gatchev-XID over 8 years ago

TI__Guru**** 393215 points

Hi,

TI will not discuss what can happen if the device is used out of specifications. Please follow the datasheet requirements.

0 Robert Noe over 8 years ago in reply to Biser Gatchev-XID

Intellectual 440 points

What about Maximum Slew that there aren't any requirements in datasheet!

0 kshin over 8 years ago in reply to Robert Noe

TI__Genius 16690 points

I can see that the maximum slew is defined in the datasheet. If you are asking the minimum slew rate, there is no requirement.

Processors

Processors forum

AM4376: Power-up sequence questions