RTOS/TDA2EVM5777: Demo code can't run

Andy Dong

Prodigy 250 points

Part Number: TDA2EVM5777

Tool/software: TI-RTOS

Hi everyone,

As the title said

I just copy MLO & AppImage into SD card and run the Single Camera Usecases f

and it didn't work.

I didn't edit any documents in vision_sdk folder.

By the way, the userguide said I need to format SD card to (fs = fat32 unit = 512 label = SD_BOOT)

but I can't set unit = 512 , I just format SD card to ( fs = fat32 label = SD_BOOT).

Does it cause any problems?

Regards,

Andy

over 8 years ago

0 Yordan Kamenov over 8 years ago

TI__Mastermind 42515 points

Hi Andy,

you need to place the file 'SFM_POSE.bin' on the SD card too.
Please check VisionSDK_UserGuide_TDA2xx.pdf chapter "3.9.1 Single channel demos with HDMI input".

Regards,
Yordan

0 Andy Dong over 8 years ago in reply to Yordan Kamenov

Prodigy 250 points

hi,Yordan

Thanks for your reply.
Where can I get the file 'SFM_POSE.bin' ?
I didn't find in my vision sdk folder.

Regards,
Andy

0 Yordan Kamenov over 8 years ago in reply to Andy Dong

TI__Mastermind 42515 points

Hi Andy,

it is part of VISION_SDK_02.XX.XX.XX_INPUTS.tar.gz which can be found on CDDS:
cdds.ext.ti.com/.../emxNavigator.jsp

(If you do not have access to CDDS you need to contact your local TI's FAE)

Regards,
Yordan

Processors

Processors forum

RTOS/TDA2EVM5777: Demo code can't run