TDA2SX: EVM boot guide

user5052034

Part Number: TDA2SX

Hi TI Experts，

I have got a TDA2SX EVM CPU board today .I connected it with a HDMI monitor and power the EVM board ,but there is no information displayed on the monitor.

Shall I download any kind of firmware to program the flash or download Linux OS to the SD card for booting the EVM board?

Could you help to provide a boot guide link for me about this EVM board?

over 8 years ago

0 Yordan Kamenov over 8 years ago

TI__Mastermind 42515 points

Hi,

here is the TDA2x EVM's User's Guide
www.ti.com/.../sprui51.pdf

Also which SDK you use? Please check the VisionSDK_UserGuide_TDA2xx.pdf from docs/ directory in your VisionSDK installation.

Regards,
Yordan

0 user5052034 over 8 years ago in reply to Yordan Kamenov

Prodigy 180 points

Hi Yordan,
I have checked this user‘s guide before,but it seems there is no notification for install any kind of software.So no software or SDK are installed by me now.I suppose this EVM board could boot and display on the monitor with the factory configuration. Correct me if I am wrong.

0 user5052034 over 8 years ago in reply to user5052034

Prodigy 180 points

Hi Yordan,
I'd like to add one question:Has the boot software been programmed to the NAND flash or Nor Flash after factory test?

Processors

Processors forum

TDA2SX: EVM boot guide