CCS/TMS320C6678: On our C6678, we use our Broadcom PHY, How to add our PHY configuration into NDK helloWorld.pjt

francis

Intellectual 480 points

Part Number: TMS320C6678

Tool/software: Code Composer Studio

Hi,

dear,

With our midification for PHY Registers, we can run GE.pjt from K1_STK_v1.1

How to add our PHY configuration into NDK helloWorld.pjt?

Thanks!

over 7 years ago

0 Yordan Kovachev over 7 years ago

TI__Guru**** 161600 points

Hi,

I've notified the sw team. Their feedback will be posted directly here.

Best Regards,
Yordan

0 francis over 7 years ago in reply to Yordan Kovachev

Intellectual 480 points

Thanks!

0 lding over 7 years ago in reply to francis

TI__Guru* 95265 points

Hi,

Can you clarify what GE.pjt from K1_STK_v1.1 it is? I am not sure if it is part of TI Processor SDK RTOS. And you mentioned you modified the PHY registers, I believe it is C code, why can't be added into any CCS project?

Regards, Eric

0 francis over 7 years ago in reply to lding

Intellectual 480 points

Thanks!

We downloaded the package from the Chinese support site:

www.deyisupport.com/.../47664.aspx

which is distributed by Chinese TI employee.

And use the GE.pjt in the package.

We think TI's helloWorld.pjt from ndk has integrated configuration and support for the PHY used in EVM6678.

But we use another Broadcom PHY, so we have to modify helloWorld.pjt.

0 francis over 7 years ago in reply to lding

Intellectual 480 points

K1_STK_v1.1.zip 20171123-GE and NDK's helloWorld comparing.docx

0 francis over 7 years ago in reply to lding

Intellectual 480 points

1106.K1_STK_v1.1.zip

0 francis over 7 years ago in reply to lding

Intellectual 480 points

Several years ago we use C6455 with our custom Broadcom PHY BCM5464R (which is also used now for our C6678 board).
We don't mofidy any code and run helloWorld successfully (from ndk_2_0_0_0 package).
The interface of C6455 is RGMII and now for C6678 it's SGMII.

Processors

Processors forum

CCS/TMS320C6678: On our C6678, we use our Broadcom PHY, How to add our PHY configuration into NDK helloWorld.pjt