RTOS/TDA2EVM5777: 2d/3d calibration

Xing Wang23

Part Number: TDA2EVM5777

Tool/software: TI-RTOS

Hi,

I'm trying to do the calibration step on TDA2x system and getting confused by the checkers that VisionSDK provides.

2d calibration is using this pattern:

3d calibration is using this pattern:

Why does this happen? Can I just use the same pattern for both cases? Can I even use customized checkers?

Thanks,

Xing

0 Yordan Kamenov over 8 years ago

Hi Xing,

I have forwarded your question to an expert for comment.

Regards,
Yordan

0 Shiju Sivasankaran over 8 years ago in reply to Yordan Kamenov

Hi Xing

below the charts you should use for calibration

For 2D SRV: \vision_sdk\apps\tools\surround_vision_tools\docs\Checkers_for_2D_calibration.doc

For 3D SRV: \vision_sdk\apps\tools\surround_vision_tools\docs\poster_calib_chart.pdf

I am coping Shashank to comment on your other queries

>>> Can I just use the same pattern for both cases? Can I even use customized checkers?

regards, Shiju

0 Xing Wang23 over 8 years ago in reply to Shiju Sivasankaran

Any news from Shashank?

0 Shashank Dabral over 8 years ago in reply to Xing Wang23

Hi,
Only the charts mentioned in the thread are supported.

Regards
Shashank

Processors forum