OMAP-L138 EVM EMIFA expansion connector breakout board

Don Froese

Other Parts Discussed in Thread: OMAP-L138

I want to connect an FPGA to my OMAP-L138 EVM using the EMIFA connector J28.

Does anyone know of a breakout cable/proto-board/Xilinx dev board that would plug directly into this connector ( DF40C-100DS-0.4V(51) )?

I'm sure I am not the only person who wants to do this.

Thanks,

-Don

over 14 years ago

0 Mukul Bhatnagar over 14 years ago

TI__Guru* 83825 points

Don

I am not aware of anything available from the TI, LogicPD or Spectrum Digital portfolio at the moment, that would let hook up an FPGA directly via J28 connector on the EVM. There have been requests for breakout boards , but unfortunately so far either customers are developing their own boards or own break out cables etc.

If there is someone in the community that has created a re-usable solution, hopefully they will pitch in on this thread.

Regards

Mukul

0 A4 K7 over 14 years ago

Intellectual 310 points

Don, Mukul,

There is an adapter from this website ( http://www.createnewstuff.com/ ) that breaks out the tiny connector to 0.100" standard headers.

Hope this helps.

0 Don Froese over 14 years ago in reply to A4 K7

Prodigy 60 points

That is very helpful, thanks alot. we have just finished designing our own adapter board. Wish I had seen this sooner!

0 Mukul Bhatnagar over 14 years ago in reply to Don Froese

TI__Guru* 83825 points

I somehow missed this post. Thanks for sharing the info indeed.

Regards

Mukul

Processors

Processors forum

OMAP-L138 EVM EMIFA expansion connector breakout board