DM6467 debugging issue

Are you getting any warnings when building or loading the project?

When you say it does not make it to main where does the program counter actually end up?

MH said:

My program use DSP/BIOS but as I understood it does not supposed to make a differense, right?

Certainly, both BIOS and non BIOS based projects should be able to make it to main, BIOS itself (the scheduler) only really starts after main exits.

I think that the problem is that I am using DSPLNIK and that I should run both the ARM code and the DSP code.

Do you know the way to do it?

Thanks.

If you have a generic DSP application and you don't care about having the ARM running than you should be able to load and run the DSP application to main (if this does not work than there could be other underlying issues), if the ARM was holding the DSP in reset or otherwise preventing execution than I would expect CCS to pop up errors upon trying to connect.

If you do want to use both ARM and DSP at the same time while debugging I think the best reference is this wiki article.

Thank you Bernie. That article do help a lot.