CCS/BEAGLEBOARD-X15: AER support

The software team have been notified. They will respond here.

Tarun,

Unfortunately, we don't provide an example on running an AER demo on the X15. You will have to take a look at the documentation in software-dl.ti.com/.../index_FDS.html and create an example.

Lali

Can u share any link describing how to run AER on any board say beagle board xm

Ti is test set up for AER testing
The pre-built Cortex-A8 test code runs on a Beagle Board or TI813x EVM. Follow procedures
below:
• Make a directory path on a Beagle Board or TI813x EVM: aertest/lnkr/gcarmv7a.
• Put the pre-built executable aertest_cortexA8.xv7A (located at lnkr/gcarmv7a of the
installed AER test package) to folder /gcarmv7a created above.
• Put the AER simulation configuration file aersimcfg.txt (located at root of the installed
AER test package) to folder /aertest created above.
• Make directory paths: aertest/vectors/inp and aertest/vectors/out.
• Put files listed below (located at vectors/inp of the installed AER test package) to folder
/inp created above:
• fe_16k.pcm
• ne_pink_16k.pcm
• Run aertest/lnkr/gcarmv7a/aertest_cortexA8.xv7A and compare outputs aertest/vectors/
out/rxout.pcm and txout.pcm against references: rxOutRef_CortexA8.pcm and
txOutRef_CortexA8.pcm (located at installed package ti/mas/aer/test/vectors/refOut/)



I have pre-built executable aertest_cortexA8.xv7A.. but I dont know how to run this executable on beagle board-xm.
is there is any option in CCS to run directly this executable.
I have also set up this board for linux set up using std kernal image for beagleboard-xm..

Already I had been to this link
I have installed this package and tried to run pre-built executable aertest_cortexA8.xv7A.But i dont know how to run this pre-built executable on bagleboard-xm