RTOS/AM5728: Ethernet access from DSP

Walid Ben Saad

Part Number: AM5728

Tool/software: TI-RTOS

Hi all, i want to use a TCP IP communication in DSP so how can I configure the eth0 to be used from the DSP(ti-rtos) not Linux

over 7 years ago

0 Biser Gatchev-XID over 7 years ago

TI__Guru**** 393215 points

The RTOS team have been notified. They will respond here.

0 Sahin Okur over 7 years ago

TI__Mastermind 27355 points

Hello,

Please take a look at our NDK/NIMU examples in Processor SDK RTOS. Refer to the following page for more information:

0 Walid Ben Saad over 7 years ago in reply to Sahin Okur

Prodigy 150 points

thank you for your reply, but i need to know if i can intialize the ethernet device to be used by the DSP (knowing that DSP is launched by A15 (Linux))

0 Sahin Okur over 7 years ago in reply to Walid Ben Saad

TI__Mastermind 27355 points

Yes this can be done by adding IPC to your application. See software-dl.ti.com/.../How_to_Guides.html

Processors

Processors forum

RTOS/AM5728: Ethernet access from DSP