RTOS/TDA2: Update appimage by SD card

Tn Zaku02

Part Number: TDA2

Tool/software: TI-RTOS

Hi Expert,

I'm running PROCESSOR SDK VISION V3.04 RTOS on xc5777x evm.
Using the "Load using QSPI" to launch the board, how do I update the appimage with the sd card?

Could you please give some suggestion here?
Thanks in advance.

over 7 years ago

0 Rishabh Garg over 7 years ago

TI__Guru 55685 points

Hi,

Can you look at "Load using SD card" section of VisionSDK_UserGuide_TDA2xx.pdf.

Regards,
Rishabh

0 Tn Zaku02 over 7 years ago in reply to Rishabh Garg

Intellectual 880 points

Hi,

I need the sd card to update the appimage inside the QSPI flash.
"Load using SD card" section only boot?

Thanks in advance.

0 Rishabh Garg over 7 years ago in reply to Tn Zaku02

TI__Guru 55685 points

Hi,

Unfortunately we don't have any application that will read the image from SD card and flash it to QSPI.
You need to write this application yourself by referring to PROCESSOR_SDK_VISION_03_04_00_00\ti_components\drivers\pdk_01_10_00_08\packages\ti\drv\stw_lld\examples\mmcsd\sd_file_io and PROCESSOR_SDK_VISION_03_04_00_00\ti_components\drivers\pdk_01_10_00_08\packages\ti\boot\sbl_auto\qspiflash\examples\qspi_flash_writer.

Regards,
Rishabh

0 Rishabh Garg over 7 years ago in reply to Rishabh Garg

TI__Guru 55685 points

Hi,

I haven't heard back from you, I'm assuming you were able to resolve your issue.
If not, just post a reply below (or create a new thread if the thread has locked due to time-out).

Regards,
Rishabh

Processors

Processors forum

RTOS/TDA2: Update appimage by SD card