RTOS/TDA2: TIDL ssd result different on EVE platform and PC

Hi
Can you share the make command used for building PC host emulation ?

gmake TARGET_PLATFORM=PC TARGET_BUILD=release CORE=eve all

and

gmake TARGET_PLATFORM=PC TARGET_BUILD=release CORE=eve RUN_REF_FOR_STATS=1 all

i try both the above two command, but the result is similar.

With the below command it is expedted to match with EVE target
gmake TARGET_PLATFORM=PC TARGET_BUILD=release CORE=eve all
but not for the other.

Can you enebale layer level trace for PC and target and locate the miamatching layer

how i can enable layer level trace , and when enable the layer level trace what Ican see?

do you mean I can enable layer level trace by enable below define?
#define ENABLE_TRACE_DUMP (1)
but when I enable this, on the eve platform i can not successfully build appimage

on pc, when enable this define, i can get layer level trace data.

Hi

how i can enable layer level trace for target.

thanks.

You need to build standalone test application for EVE and run using JATG and CCS

Hi:

when i load eve_test_dl_algo.out, i encountered follow problem:

ARP32_EVE_1: Trouble Reading Memory Block at 0x0 on Page 0 of Length 0xad: (Error -1065 @ 0x0) Unable to access device memory. Verify that the memory address is in valid memory. If error persists, confirm configuration, power-cycle board, and/or try more reliable JTAG settings (e.g. lower TCLK). (Emulation package 5.1.232.0)

can you help me to look at what the probelm.

i can load dsp_test_dl_algo.out successfully.

i use simulator to run the standalone test, but i can not get layer level trace data. And the result between standalone test and PC differs some pixels for the detected box, is this expected.

Can you check below flag in *multicore_reset.gel for loading code in EVE

#define EVE_SW_CONFIG 1 /* Applicable for EVE_SW users only
* Effective only when
* VISION_SDK_CONFIG == 0
*/

in which package and which directory i can find *multicore_reset.gel

thanks

thanks, i find the .gel file

i still can not load program into eve with jtag. i changed the value you said.