RTOS: Display link output statics

Kajal Karande

Expert 1655 points

Tool/software: TI-RTOS

Hello,

I want to clear doubt regarding display link statics.

For any use case , when we print statics for display link there no output statics.

Why is it so?

Regards,

Kajal.

over 6 years ago

0 Rishabh Garg over 6 years ago

TI__Guru 55685 points

Hi Kajal,

There is no output from display link and hence there is no output statistic.

Regards,
Rishabh

0 Kajal Karande over 6 years ago in reply to Rishabh Garg

Expert 1655 points

Okay.
Meaning output frames are going to display drivers for displaying them. ( i. e. FVID2_Frame for that purpose)
Is my understanding correct??
Regards,
Kajal

0 Rishabh Garg over 6 years ago in reply to Kajal Karande

TI__Guru 55685 points

Kajal,

Input frame is being used by display driver for displaying data.
After the frame display is complete, the driver returns the frame to the application.
You can also refer to use case diagram.

Regards,
Rishabh

0 Kajal Karande over 6 years ago in reply to Rishabh Garg

Expert 1655 points

Hello Rishabh,

About which use case digram you are talking?

Regards,
Kajal

0 Rishabh Garg over 6 years ago in reply to Kajal Karande

TI__Guru 55685 points

Hi Kajal,

You can look at any Vision SDK use case jpg. E.g. PROCESSOR_SDK_VISION_03_05_00_00\vision_sdk\apps\src\rtos\usecases\vip_single_cam_frame_copy\chains_vipSingleCameraFrameCopy.jpg
Display link is the last block. The output does not go to any other link.
Hope this clarifies.

Regards,
Rishabh

0 Kajal Karande over 6 years ago in reply to Rishabh Garg

Expert 1655 points

Okay Rishabh, thank you for clarification.

Regards,
Kajal

0 Rishabh Garg over 6 years ago in reply to Kajal Karande

TI__Guru 55685 points

Closing the thread as issue has been resolved.

Regards,
Rishabh

Processors

Processors forum

RTOS: Display link output statics