RTOS/TDA3: TDA3 rvp

raffaele memmolo

Prodigy 170 points

Part Number: TDA3

Tool/software: TI-RTOS

Hello ,

i follow the user guide ,but i did not understand how to load sbl in tda3x starter kit.

The first step is CPU reset. How to perform CPU reset?

What is SW switch?

Can you explain step by step?

over 6 years ago

0 Rishabh Garg over 6 years ago

TI__Guru 55685 points

Hi Raffaele,

Did you flash the SBL in QSPI? We have not worked with TDA3 starter kit and hence won't be able to help with exact steps.
I will forward this query to D3 and they will get back to you with more details.

Regards,
Rishabh

0 raffaele memmolo over 6 years ago in reply to Rishabh Garg

Prodigy 170 points

I did not understand how to flash SBL in QSPI. this is the problem. I followed the guide, but the flashing was unsuccessfully.
can you help me?

0 Rishabh Garg over 6 years ago in reply to raffaele memmolo

TI__Guru 55685 points

Raffaele,

Are you able to connect to IPU1_0 using CCS?

Regards,
Rishabh

0 raffaele memmolo over 6 years ago in reply to Rishabh Garg

Prodigy 170 points

At this moment, i have no JTAG emulator to connect CCS to the board.
Another solution?

0 Rishabh Garg over 6 years ago in reply to raffaele memmolo

TI__Guru 55685 points

Raffaele,

I am not sure if Mflash will work on TDA3 starter kit, you can give it a try.
Refer to PROCESSOR_SDK_VISION_03_06_00_00\ti_components\drivers\pdk_01_10_02_07\packages\ti\boot\sbl_auto\tools\mflash.
You should use tda3xx-rvp mflash executable.
The app note is here: www.ti.com/.../spracc3.pdf

Regards,
Rishabh

Processors

Processors forum

RTOS/TDA3: TDA3 rvp