PROCESSOR-SDK-TDAX: Switches

Mostafa Elrafei

Hello all,

I use 'TDA3XX RVP A board' , and there is three switches Sw1 ,sw2 and sw3 what these switches is used for , or tell me in which document in SDK conatins info about this switches and their use .

over 6 years ago

0 Rishabh Garg over 6 years ago

TI__Guru 55685 points

Hi,

Can you refer to PROCESSOR_SDK_VISION_03_06_00_00\vision_sdk\docs\UserGuides\VisionSDK_UserGuide_TDA3xx_RVP.pdf.

Regards,
Rishabh

0 Mostafa Elrafei over 6 years ago in reply to Rishabh Garg

Intellectual 390 points

Hello Risbah,

This info is not in the document you specified, D3 engineering shall put this info in one of it's documents but I don't know whic

0 Rishabh Garg over 6 years ago in reply to Mostafa Elrafei

TI__Guru 55685 points

Hi Mostafa,

I am not aware of D3 documentation. Can you please check with D3 for quick reply. I will notify D3 of this thread at my end.

Regards,
Rishabh

0 BenM over 6 years ago in reply to Rishabh Garg

Expert 2220 points

Hello,

On the FPD Link Board:

SW1 - Not populated, controls the UB960 test enable pin

SW2.1 SYSBOOT4 - ON Position pulls pin Down

SW2.2 SYSBOOT3 - ON Position pulls pin UP

SW2.3 I2C Mux Control for access EDID EEPROM

SW2.4 EDID Write Protect

On SOM

SW1 - SYSBOOT4 - ON Position pulls pin Down

SW2 - SYSBOOT3 - ON Position pulls pin Up

Cheers,

Ben

0 Rishabh Garg over 6 years ago in reply to BenM

TI__Guru 55685 points

Hi Mostafa,

I am closing this thread as Ben has provided necessary details.
In case you have further questions please post a reply or start a new thread.

Regards,
Rishabh

Processors

Processors forum

PROCESSOR-SDK-TDAX: Switches