Part Number: AM4379
Tool/software: TI-RTOS
I succeed to run "GPIO_LedBlink_skAM437x_armTestProject" on AM437x Starter Kit.
Now, I am trying to run this example code on our custom design board with AM4379.
As I understand it, i must use PinMux Tool for pin differences with Starter Kit and our custom board.
But i cannot understand, how to use pin mx tool generated files (am43xx_pinmux.h, am43xx_pinmux_data.c, devicetree.stsi and PinmuxConfigSummary.csv )
I examined http://www.ti.com/lit/an/sprac44a/sprac44a.pdf and related posts.
As I understand from related post, we cannot use this generated files directly, we must use this informations/datas to edit u-boot files.
But as far as I know, the example project (GPIO_LedBlink_skAM437x_armTestProject) does not have u-boot i think.
I was able to run "GPIO_LedBlink_skAM437x_armTestProject" example on AM437x Starter Kit, and i did not see any u-boot files..
How can i use these generated files on our custom board, can you explain a little more ?
As I said before, i am newbie. My questions can be a little simple.
Thank you for your interest
Regards,
Mehmet
