Linux/AM3358: Enabling second Ethernet on beaglebone black

kumuda M

Part Number: AM3358

Tool/software: Linux

Hi,

How to enable second Ethernet (eth1) of Beaglebone black

eth0 is default , we brought out the pins of second ethernet and hardware circuit is ok but how to get eth1 and what we need to change in firmware

Actually in the below link they said at a time we can use only one ethx but we want both how to use

processors.wiki.ti.com/.../Linux_Core_CPSW_User's_Guide

Thanks

kumuda

over 6 years ago

0 Biser Gatchev-XID over 6 years ago

TI__Guru**** 393215 points

Hi,

If you are using the Debian release that comes with Beaglebone Black, this is not supported by TI and you have to ask the community on

If you are using the Processor SDK provided by TI, documentation is available here:

Look in section "Dual Standalone EMAC mode".

0 kumuda M over 6 years ago in reply to Biser Gatchev-XID

Prodigy 250 points

Hi,

Thanks for the response.

We are bringing up the new board using am335x in that we are enabling two ethernet ports. After enabling in Hardware, how to configure that in Firmware to enable eth0 and eth1 in bootup time?

Regards

Kumuda

0 Krunal Bhargav34 over 6 years ago in reply to kumuda M

TI__Mastermind 45015 points

Hello,

Please refer to the following guide as a reference.

Regards,

Krunal

Processors

Processors forum

Linux/AM3358: Enabling second Ethernet on beaglebone black