Clarifications on "Flashing Boot Images on Linux Without CCS" procedure

GrantHatamosa

Expert 1930 points

Other Parts Discussed in Thread: OMAP-L138

We are using a custom board with OMAP-L138 in it. We currently don't have a JTAG emulator that can allow us to use CCS.

Looking through the wiki I found this link to boot the OMAP without CCS.

http://processors.wiki.ti.com/index.php/GSG:_DA8x/OMAP-L1/AM1x_DVEVM_Additional_Procedures#Flashing_Boot_Images_on_Linux_Without_CCS

However, the ini files indicated through this link cannot be opened: http://processors.wiki.ti.com/index.php/File:OMAP-L138_inifiles.zip

Can you please advise me if I am on the right path?

Should I be going through this procedure to get a custom board loaded with u-boot or is their a much easier way of doing it?

over 14 years ago

0 clam over 14 years ago

TI__Expert 8785 points

For your issue, this wiki link is a good reference, http://processors.wiki.ti.com/index.php/Serial_Boot_and_Flash_Loading_Utility_for_OMAP-L138. It is very similar to the other instructions.

--Christina

0 jc-ti over 14 years ago

TI__Mastermind 27585 points

For a custom board, the link to the serial flasher that Christina gave would be the easiest. Please note that you will probably have to rebuild the flasher in order to match the UART number used (if something other than 2) and to update the DDR timings if you are using different memory than is on the EVM. Instructions for this are found in the previous wiki link as well.

Jeff

Processors

Processors forum

Clarifications on "Flashing Boot Images on Linux Without CCS" procedure