TDA3XEVM: Adding custom board to Vision SDK project

Claes Ivarsson

Prodigy 80 points

Part Number: TDA3XEVM

Hi,

I would like to know how to add support for our custom board into both a Vision SDK- and PDK-based project.

Please note that we would like to place these files outside of the SDK installed path (like previously discussed)

Regards

Claes

PS: I will be off for a couple of weeks which means it is not a hurry right now, but will be when I am back in beginning/middle of August.

over 7 years ago

0 Rishabh Garg over 7 years ago

TI__Guru 55685 points

Hi Claes,

You need to add the custom board in PROCESSOR_SDK_VISION_03_07_00_00\ti_components\drivers\pdk_01_10_03_07\packages\ti\drv\vps\src\boards.

Depending on the components you need and the use case you will need to make changes in other places as well.

I would suggest you to open a thread when you are ready to work on this.

Regards,

Rishabh

0 Rishabh Garg over 7 years ago in reply to Rishabh Garg

TI__Guru 55685 points

Hi Claes,

Is there an update on this issue?

Regards,

Rishabh

0 Joakim Jarfjord over 7 years ago in reply to Rishabh Garg

TI__Expert 4720 points

Hi Rishabh,

We are working directly with Claes to sort out all the details on this topic offline. If this result in something generic that makes sense to share with a wider audience, we need to consider updating this e2e thread later. But for now, consider this topic closed here.

Thanks and regards,

Joakim

Processors

Processors forum

TDA3XEVM: Adding custom board to Vision SDK project