[DRA829] MLB pins

Takeo Sekiguchi

Expert 3305 points

Hello,

Is it able to leave unconnected below MLB pins?

MLB0_MLBCN / MLB0_MLBCP / MLB0_MLBDN / MLB0_MLBDP / MLB0_MLBSN / MLB0_MLBSP

Regards,

Takeo

over 6 years ago

0 Stanislav Stilyanov over 6 years ago

TI__Mastermind 24990 points

Hi Takeo,

These fall into this category in Datasheet:

All other unused signal balls with a Pad Configuration Register can be left unconnected with
their multiplexing mode set to GPIO input and internal pulldown resistor enabled.

Regards,

Stan

Processors

Processors forum

[DRA829] MLB pins