C6A8168 's temperature is very high, is it suitable for handhold device?

I tested C6A8168 and I think it only run at 1GHz~1.2GHz, not 1.5GHz.

So it will too hot to work at 1.5GHz, won't it?

I enable bogomips test in Linux kernel:

Calibrating delay loop... 986.31 BogoMIPS (lpj=4931584)

It must run at 1GHz, not 1.5GHz.

???????????????????????????????????????????????

Thank you, Marc.

For me, it is hard to accept the heat dissipation when arm run 1GHz, and can not even figure out how heat it ran at 1.5G Hz.

Base on my OMAP3530 experience, 3D graphic acceleration may be very hot, I notice TI promote the C6A8168's 3D acceleration module to 333MHz, which is over 3 times of the OMAP3530's.  In fact, I think 200MHz 3D acceleration module is acceptable, so I advise TI to adopt a lower frequency to reduce heat to gain larger market.

Or if you can tell me how to modify the 3D acceleration module frequency by software, I will try to decrease it to test.

DM37xx may be more suitable, thank you.