C6745 questions

Yes you can do this with code composer. You can get the CCS-based flashing tools from the DVSDK found in the Software links on the product page.

Jeff

Since you have the XDS100v2 board, you should be using CCS4.  When you create a target configuration for you board, you can specify the Texas Instrument XDS100v2 USB Emulator and select the C6745 from the list of parts.  That should be all you need to load & debug code on the device.

Information on XDS100v2:

http://processors.wiki.ti.com/index.php/Xds100v2

You can follow similar instructions as for the C6748, the difference will be in the GEL files you use (you can probably reuse the C6747/OMAP-L137 GEL files from Spectrum Digital) and the part number selection of course.

http://processors.wiki.ti.com/index.php/How_to_connect_to_the_OMAP-L138/C6748/AM1808_EVM_board_using_CCS%3F#XDS100v2.2C_XDS510_or_XDS560_external_emulator_-_DSP_.2B_ARM_.28C6748_SOM.29

http://support.spectrumdigital.com/boards/evmomapl137/revg/

To create the boot image for your code, refer to the bootloader app note:

http://focus.ti.com/dsp/docs/litabsmultiplefilelist.tsp?sectionId=3&tabId=409&literatureNumber=sprabb1b&docCategoryId=1&familyId=1622

The flashing of the image to your serial flash will depend on your hook up on your board.  If you used the same SPI flash as on the C6747/OMAP-L137 EVM and connected it to the same SPI port, then you should be able to follow these steps:

http://processors.wiki.ti.com/index.php/Flashing_the_C6747