AM3359: HSR/PRP test setup

Pankaj Suryawanshi

Part Number: AM3359

Hi Community,

I am trying to understand HSR/PRP protocols and ti rtos examples of same.

but i am not able to understand, how to test HSR/PRP application and what functionality need to be tested to verify HSR/PRP ?

I also dont know what setup is needed to test HSR/PRP ? , What is Redbox ?

How to create the setup to test HSR and PRP ?

Any help would be appreciated.

Regards,

Pankaj

over 6 years ago

0 Garrett Ding over 6 years ago

TI__Mastermind 43296 points

Pankaj,

Please review the TI designs of HSR and PRP:

High-Availability Seamless Redundancy (HSR) Ethernet for Substation Automation: http://www.ti.com/lit/ug/tidub08/tidub08.pdf

Parallel Redundancy Protocol (PRP) Ethernet Reference Design for Substation Automation:

These documents refer to old industrial SDK, but the test setup is the same for the new PRU-ICSS software.

Regards,

Garrett

0 Pankaj Suryawanshi over 6 years ago in reply to Garrett Ding

Expert 1110 points

Hi Garrett,

Thanks for useful information.

I am working with TI-RTOS and I am running HSR/PRP application in which following menu is showing, when i tried to TX/RX it hang in Rx side.

Test Setup for PRP is using 2 board, Two Switches each port of board is connected to switch.

When i tried tx/rx testing it hangs at rx side. Please let me know if i missing anything

HSR/PRP Application Menu Options. Press key (Upper/Lower)
*******************************************
S : Show Statistics
L : Show LRE Statistics
C : Show HSR/PRP Configuration
N : Show Ring members/Node Table
M : Multicast filter handling
V : VLAN filter handling
F : Host Rx Interrupt Config | 0 : Disable | 1. Enable | 2. Enable with Adaptive Logic
I : Assign IP address
P : Show PTP/1588 status
R : Run Rx/Tx test
H : Help menu. Shows details on all the options

Regards,

Pankaj

0 Garrett Ding over 6 years ago in reply to Pankaj Suryawanshi

TI__Mastermind 43296 points

Refer to https://e2e.ti.com/support/processors/f/791/p/872112/3226611#3226611

Processors

Processors forum

AM3359: HSR/PRP test setup