Compiler/TDA2SX: running usecases on custom board

Alex Belyaev

Part Number: TDA2SX
Other Parts Discussed in Thread: TDA2

Tool/software: TI C/C++ Compiler

Hello! I have custom board with TDA2 and custom pin configuration. I need to run usecases from radar SDK on this board. Which parameters i need to change before building AppImage for successful running?

Thanks,

Alex

over 5 years ago

0 Yordan Kamenov over 5 years ago

TI__Mastermind 42515 points

Hi Alex,

can you try to change the pimnux in in ti_components/drivers/pdk_01_10_04_05/packages/ti/drv/vps/src/platforms/src/bsp_platformTda2xx.c according to your board settings and see if it works?

Regards,

Yordan

0 Alex Belyaev over 5 years ago in reply to Yordan Kamenov

Intellectual 272 points

Hi Yordan,

I looked through this file, its almost what i need, but i didnt find ethernet pins. Is it in other .c file or i don't need configure ethernet pins?

Regards,

Alex

0 Yordan Kamenov over 5 years ago in reply to Alex Belyaev

TI__Mastermind 42515 points

Hi Alex,

Sorry for the delayed response. Can you check the patch vision_sdk/docs/Patches/0001-PAD-Mux-changes-to-enable-Dual-MAC.patch and see if it can give you any directions.

Regards,

Yordan

0 Alex Belyaev over 5 years ago in reply to Yordan Kamenov

Intellectual 272 points

Thanks!

Processors

Processors forum

Compiler/TDA2SX: running usecases on custom board