According to the picture below:
I want to send some data to「Slave」by I2C.
Now, it's no problem to send data to「DES」and「SER」, but I can't send data to「Slave」by I2C successfully.
I have set「Slave ID」(0x08) and「Slave Alias」(0x10) with "0xA0".
After I send something to「Slave」(sensor),
I get this error message.
According to the picture below:
I want to send some data to「Slave」by I2C.
Now, it's no problem to send data to「DES」and「SER」, but I can't send data to「Slave」by I2C successfully.
I have set「Slave ID」(0x08) and「Slave Alias」(0x10) with "0xA0".
After I send something to「Slave」(sensor),
I get this error message.
I find the document "I2C over DS90UB913 and 914 FPD-Link III with Bidirectional Control Channel",
and it refer to：「camera sensor has physical I2C address of 0x50」
Then I try to look for camera datasheet (imx224)：
So I program as below：
Finally, console doesn't receive error message about I2C.
