AM3352: dual network issue

Jian Xiule

Part Number: AM3352

Hi，

Have a good day!

Customer use Dual network port of am3352, when he close eth0, eth1 will not work. he use the ifconfig eth0 down command. Are the two network cards not isolated?

over 4 years ago

0 Nick Saulnier over 4 years ago

TI__Guru* 93285 points

Hello Jian,

What version of software is the customer running on AM3352?

Regards,

Nick

0 Jian Xiule over 4 years ago in reply to Nick Saulnier

TI__Prodigy 260 points

Hi Nick

The kernel version I use is linux-3.2.0.

0 Nick Saulnier over 4 years ago in reply to Jian Xiule

TI__Guru* 93285 points

Hello Jian,

Linux kernel 3.2 is too old for us to support on these forums. Please migrate to a recent Linux Processor SDK if you want support from TI.

I am reassigning this to our CPSW owner to see if they recognize this behavior.

Regards,

Nick

0 Schuyler Patton over 4 years ago in reply to Nick Saulnier

TI__Mastermind 39430 points

Hi,

As Nick mentioned I would recommend the customer switches to the most recent version of the SDK. While that problem does familiar there are not solutions that are available to provide other than upgrading to the most recent SDK.

Best Regards,

Schuyler

0 Jian Xiule over 4 years ago in reply to Schuyler Patton

TI__Prodigy 260 points

Hi Schuyler and Nick,

Thanks for feedback, I will provide your advice to customer. Thanks.

Thanks

Sure

Processors

Processors forum

AM3352: dual network issue