Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: EDGE-AI-STUDIO Other Parts Discussed in Thread: AM68A , AM67A , SK-AM62A-LP Tool/software: We receive frequent queries related to SDK versions and TI Deep Learning (TIDL). Please find a series of relevant FAQ topic below. Note that these…
Part Number: TDA4VM Other Parts Discussed in Thread: TDA4VH Tool/software: The number of user configurable ALE classifier/policer entries are limited in ETHFW by dividing them in to multiple partitions, how to adjust those partitions?
Part Number: AM6442 Other Parts Discussed in Thread: AM625SIP , AM62P , AM62L
Tool/software:
Hi TI Experts,
Can you supply the pin list of the SOC in excel format?
Part Number: AM625 Other Parts Discussed in Thread: AM62A7 ,
Tool/software:
Hi TI Experts,
I have the below query
AM62A7: How can we change the drive strength of the SPI interface AM625: How to change the drive strength of the ethernet interface…
Part Number: TDA4VL-Q1 Tool/software: Does the SDL ECC test cover error injection tests on the inaccessible endpoints? If not, what is the testing procedure for these endpoints?
Part Number: TDA4VH-Q1 Tool/software: Does the SDL ECC test cover error injection tests on the inaccessible endpoints? If not, what is the testing procedure for these endpoints?
Part Number: AM623 Other Parts Discussed in Thread: AM625
Tool/software:
Usually add RC filter on RESET signal to anti noise, but the slew rate requirement of RESET signal on AM62x datasheet is quite sharp, on customer board it is about 10V-100V/ms…
Part Number: AM623
Tool/software:
#1. Did not find MMC0 HS200 slew rate data in datasheet timing section, so section 7.8.6 LVCMOS Electrical Characteristics data applies?
#2. The Min vale: 18f or 1.8E+6, the two value are quite different, 18f=18x200MHz…
When posting a new software inquiry on the TI E2E forum, please follow this guideline for the initial post.
Describing the Problem
Using the following list of questions as the template, copy and paste the questions to your post, and answer them if…
Part Number: AM67A Other Parts Discussed in Thread: SK-AM69 , SK-AM68 , AM67 , SK-TDA4VM Tool/software: How can I enable CSI2 sensors via fusion boards such as Arducam V3Link or fusion 1 daughter board (EVM577PFUSION-V1-0)?
