MMWCAS-RF-EVM: Other output signal instead of SYNC OUT

KenF

Part Number: MMWCAS-RF-EVM

Hi Vivek,

We understand " it is not possible to enable the digital SYNC OUT in single chip mode. " Can we use other output signal for that? For instance, GPIO output instead of SYNC OUT in single chip mode. Our device is AWR2243P.

Best regards,

Ken

over 4 years ago

0 Vivek Dham over 4 years ago

TI__Guru 58035 points

Hello Ken,

Unfortunately this is not configurable via an API from the host. Could you explain the need for SYNC OUT signal in single chip use case?

Regards,
Vivek

0 KenF over 4 years ago in reply to Vivek Dham

TI__Expert 7150 points

Hello Vivek,

SYNC OUT signal that you talk is (DIG)SYNC_OUT of P11 pin? (We would like to use DIG_SYNCOUT, not FM_CW_SYNCOUT).

Best regards,

Ken

+1 Vivek Dham over 4 years ago in reply to KenF

TI__Guru 58035 points

Hello Ken,

That is correct, I am referring to Dig SYNC OUT (pin P11).

regards,

Vivek

Sensors

Sensors forum

MMWCAS-RF-EVM: Other output signal instead of SYNC OUT