- Ask a related questionWhat is a related question?A related question is a question created from another question. When the related question is created, it will be automatically linked to the original question.
Hi,
Customer detected the mmwave from AWRL1432 and found no signal during chirp idle time and burst idle time. Is the expected?
Is there any way to enable TX during chirp idle time and burst idle time? Customer is concerned that there will be more time for the signal to be stable after turning TX on compared with TX always on.
Thanks,
Chris
Hi, Chris:
In the SDK firmware documentation mmwave_dfp_interface_control_document.pdf
It is mentioned in Section 2.4.14.
Best,
Zigang
