IWR1443BOOST: High accuracy lab not work with IWR1443Boost ES3 board?

Does IWR1443 ES3 work with SDK 3.0.0.8? How to ported to SDK 3.0.0.8 since ES3 only flash MetaImage?

The binary is TI provided for ES3 "high accuracy lab", how to ported the deice to the proper SDK?

Feng,

You can refer to the 14xx - mmWave SDK Demo lab to understand the modifications required in the ccs projectspec, which includes the Metaimage generation steps for IWR1443 ES3.0 and SDK 2.1. Modifications may be required in the C code as well according to the differences between SDK 1.2.0.5 and SDK 2.1.0.4.

-Nitin

Hi NITIN,
You seems not understand my question and my need. I already have the binary generated for high accuracy lab ES3 board, that means the code already modified for ES3 based on the SDK needed. How do I use this binary for flashing my board and make high accuracy lab works, The binary is specific generated and provided by TI for us work on the ES3 board.

Hi Feng,

With ES3.0, you need to flash only one binary i.e. the MetaImage. Unlike ES2.0 where you had to flash two bin files, one for the Radar SS firmware and the other for the application firmware.

Assuming you have a valid ES3.0 metaimage, select the image under Meta Image1/Radar SS in Uniflash and leave the other 3 boxes empty. You can also refer to the Flashing steps for ES3.0 defined in the 14xx - mmWave SDK Demo setup guide, just replace the ccs_debug.bin with your ES3.0 MetaImage.

Hope this helps.

Please mark this thread resolved if your question was answered.

Regards

-Nitin 

I flash the board with the binary provided in the box of Radar SS for ES3 board, the flash success, when I launch high accuracy lab and load the profile, I get no any data like I have before. I have SDK 2.1.0.4 and SDK 1.2 both installed.

Hi Feng,
Can you please indicate briefly how you managed this, I have the same issue.
Regards
Dan