CCS/TDC1000-GASEVM: How to flash and debug custom code to TDC1000-GASEVM

Nishant Sharma72

Part Number:

MSP-FET CCSTUDIO

TDC1000

Other Parts Discussed in Thread: TDC1000,

Tool/software: Code Composer Studio

I am trying to use TDC1000-GASEVM for an application. I have tested the application through GUI. Now I want to flash code developed by me on CCS to the EVM board. What are the possible ways to flash and debug code through CCS on the EVM board?

Thanks

Nishant Sharma

over 6 years ago

0 Bharat Aravamudhan over 6 years ago

TI__Genius 11015 points

Nishant,

We do not provide support CCS code for the TDC1000-GASEVM. Please let know if you would you have any particular issue on device or its application, we can help.
There is a debug tab in the GUI wherein you can write all the registry settings as well us update the firmware.

0 Nishant Sharma72 over 6 years ago in reply to Bharat Aravamudhan

Intellectual 780 points

Hi Bharat,

Thanks for the reply. In the following thread

it is written that we can flash and debug code on MSP430 avaialable at TDC1000 EVM through JTAG at J1 connector. Could you please explain how to do so?

Thanks

Nishant Sharma

0 Nishant Sharma72 over 6 years ago in reply to Bharat Aravamudhan

Intellectual 780 points

Hi Bharat,

Thanks for the reply. In the following thread

https://e2e.ti.com/support/sensors/f/1023/t/756655?tisearch=e2e-sitesearch&keymatch=TDC1000-GASEVM
Part Number: TDC1000-GASEVM Tool/software: Code Composer Studio Hi! Can I erase and reprogram the MSP430 on the TDC1000-GASEVM and TDC1000-TDC7200 dev boards (by using the MSP-FET and CCStudio )? Or is there some kind of limitation? Thanks a lot...

it is written that we can flash and debug code on MSP430 avaialable at TDC1000 EVM through JTAG at J1 connector. Could you please explain how to do so?

Thanks

Nishant Sharma

0 Bharat Aravamudhan over 6 years ago in reply to Nishant Sharma72

TI__Genius 11015 points

Nishant,

Please check online for helps regarding the flash & debug code on MSP430. You will need to install a connector at J1 and connect the JTAG MSP-FET and then flash the MSP430 with your own codes as needed. We do not provide any assistance for coding in particular.

0 Nishant Sharma72 over 6 years ago in reply to Bharat Aravamudhan

Intellectual 780 points

Bharat,

Thanks. I populated the J1 header and is able to flash TDC1000 EVM with MSPFET debugger.

Nishant Sharma

Sensors

Sensors forum

CCS/TDC1000-GASEVM: How to flash and debug custom code to TDC1000-GASEVM