• State Resolved
  • Locked Locked
  • Replies 5 replies
  • Answers 1 answer
  • Subscribers 31 subscribers
  • Views 343 views
  • Users 0 members are here
Support feedback
Options
Options

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

What interface can I use to program MSP430 on TDC evaluation board.

CCS/TDC1000-GASEVM: How to flash and debug custom code to TDC1000-GASEVM

Nishant Sharma72
Intellectual 780 points
Part Number:




MSP-FETCCSTUDIO

TDC1000




Other Parts Discussed in Thread: TDC1000,

Tool/software: Code Composer Studio

I am trying to use TDC1000-GASEVM for an application. I have tested the application through GUI. Now I want to flash code developed by me on CCS to the EVM board. What are the possible ways to flash and debug code through CCS on the EVM board? 

Thanks

Nishant Sharma

  • 0
    TI__Genius 11015 points
    Nishant,

    We do not provide support CCS code for the TDC1000-GASEVM. Please let know if you would you have any particular issue on device or its application, we can help.
    There is a debug tab in the GUI wherein you can write all the registry settings as well us update the firmware.
  • 0 in reply to Bharat Aravamudhan
    Intellectual 780 points

    Hi Bharat,

    Thanks for the reply.  In the following thread 

    it is written that we can flash and debug code on MSP430 avaialable at  TDC1000 EVM through JTAG at J1 connector. Could you please explain how to do so?

    Thanks 

    Nishant Sharma

  • 0 in reply to Bharat Aravamudhan
    Intellectual 780 points

    Hi Bharat,

    Thanks for the reply. In the following thread

    https://e2e.ti.com/support/sensors/f/1023/t/756655?tisearch=e2e-sitesearch&keymatch=TDC1000-GASEVM
    Part Number: TDC1000-GASEVM Tool/software: Code Composer Studio Hi! Can I erase and reprogram the MSP430 on the TDC1000-GASEVM and TDC1000-TDC7200 dev boards (by using the MSP-FET and CCStudio )? Or is there some kind of limitation? Thanks a lot...

    it is written that we can flash and debug code on MSP430 avaialable at TDC1000 EVM through JTAG at J1 connector. Could you please explain how to do so?

    Thanks

    Nishant Sharma

  • 0 in reply to Nishant Sharma72
    TI__Genius 11015 points
    Nishant,

    Please check online for helps regarding the flash & debug code on MSP430. You will need to install a connector at J1 and connect the JTAG MSP-FET and then flash the MSP430 with your own codes as needed. We do not provide any assistance for coding in particular.
  • 0 in reply to Bharat Aravamudhan
    Intellectual 780 points
    Bharat,

    Thanks. I populated the J1 header and is able to flash TDC1000 EVM with MSPFET debugger.

    Nishant Sharma