AWR1642: DCA1000

Allin Joe

Part Number: AWR1642
Other Parts Discussed in Thread: DCA1000EVM

After extracting raw data as .bin file by using dca1000 board over awr1642 board I need to do object classification using Matlab or Code Composer Studio. It will be helpful if you can share Matlab or Code Composer Studio code for object classification from .bin file.

over 6 years ago

0 Jitendra Gupta over 6 years ago

TI__Guru 69960 points

If you are capturing the raw data from mmWave Studio +DCA1000EVM then in the same GUI you can find the post-proc button which does the processing of captured data. Refer mmWave Studio user guide for more info.
software-dl.ti.com/.../index_FDS.html

And with AWR1642 you can do the embedded processing of adc data using mmw demo (from mMWave SDK).

Here is the document which has the basic script to do the signal processing of captured raw data and further you can write your own script to do the next level of processing.

http://www.ti.com/lit/an/swra581b/swra581b.pdf

If you need to know the data format of captured ADC data which is available in the below document.

http://www.ti.com/lit/an/swra581b/swra581b.pdf

http://www.ti.com/lit/an/swra555/swra555.pdf

Regards,
Jitendra

0 Allin Joe over 6 years ago in reply to Jitendra Gupta

Prodigy 170 points

Yes using this MATLAB code i will get the receiver data. I need to know whether any codes are available for object recognition of the captured Radar data.

0 Jitendra Gupta over 6 years ago in reply to Allin Joe

TI__Guru 69960 points

Hi,
I'm afraid that as of now there is no more Matlab script is available to processing on top of what I have mentioned in the last reply.

Regards,
Jitendra

Sensors

Sensors forum

AWR1642: DCA1000