AWR1243: Questions about mmwavelink project folder

huangyaohui

Part Number: AWR1243
Other Parts Discussed in Thread: , MSP430F5529

Heelo

I open the CCS folder in the mmwavelink, and there are three engineering were mmwavelink_dsp, mmwavelink_m4 and mmwavelink_r4f, what is the difference between the three? I am using AWR1243boost, so which one should I use? Or could I use whatever I want？

over 5 years ago

0 Kyle Cousino over 5 years ago

TI__Mastermind 24955 points

This will depend on the host processor or microcontroller that you are using to control the AWR1243. The AWR1243 device acts strictly as a radar front end device. You are not actually programming target code on the AWR1243. You can use these projects to develop your target application on some external processing device. These examples are provided to get you started in your application development.

Regards,
Kyle

0 huangyaohui over 5 years ago in reply to Kyle Cousino

Intellectual 520 points

Thanks for your replying. But I want to know which projection I should use if I am using the msp430f5529?

0 Kyle Cousino over 5 years ago in reply to huangyaohui

TI__Mastermind 24955 points

You should use none of these when using an MSP430. You will need to create your own project that is targeted for your specific MSP430 device and then import these five files. These three projects are architecture specific and MSP430 is not included in these three.

Regards,
Kyle

Sensors

Sensors forum

AWR1243: Questions about mmwavelink project folder