CCS/TM4C1294NCPDT: UNIFLASH 6.0.0 MAC Address programming using Command line

Shobha Patil1

Part Number: TM4C1294NCPDT
Other Parts Discussed in Thread: UNIFLASH,

Tool/software: Code Composer Studio

Hello,

I am using UniFlash v6.0.0, On unit chip is TM4C1294NCPDT.

I have to program MAC address through command line for each unit. I could not find command for it. Could you please let me know.

I really appreciate your support and Thanks in advance for your time.

0 Ki over 5 years ago

Hello

Shobha Patil1 said:
I have to program MAC address through command line for each unit. I could not find command for it. Could you please let me know.

try:

> dslite -c <TARGET CONFIG CCXML FILE> -s FlashMACAddrInput=<MAC ADDRESS> -a ProgramMACAddress

If run the command successfully but the MAC Address does not change, please see:

Thanks

0 Shobha Patil1 over 5 years ago in reply to Ki

Hi,

I really appreciate your help. Please let me know the command to commit MAC Address and read MAC address Value for UniFlash 6.0.0.

Thanks,

Shobha

0 Ki over 5 years ago in reply to Shobha Patil1

If you run the below command, it should provide all the available flash operations:

> dslite -c <TARGET CONFIG CCXML FILE> -p

For example, the flash operation for reading the MAC address is: ReadMACAddress

So the command to read the MAC address would be:

> dslite -c <TARGET CONFIG CCXML FILE> -a ReadMACAddress

Please run the below to get the full help for the dslite command:

> dslite -h

Thanks

0 Ki over 5 years ago in reply to Ki

Also see:

Thanks

0 Shobha Patil1 over 5 years ago in reply to Ki

Thanks for help..

Code Composer Studio forum