TINA/Spice: Remember diagram settings does not seem to work

Aidan Walton

Other Parts Discussed in Thread: TINA-TI

Tool/software: TINA-TI or Spice Models

Hi,

Under Analysis Options, I have enabled "Remember diagram settings". Even after running a plot, setting settings up, closing the plot, re-running, disable the remember settings running again re-enable etc etc etc. You name it. The diagram always opens with all the curves aggregated on one axis.

Any hints?

Aidan

over 6 years ago

0 John Miller - Sensing over 6 years ago

TI__Mastermind 35495 points

Aidan,

The easiest way to keep curves plotted separately is to add a colon (:) to the end of the name of one of the meters/probes.
That should force all of the curves to plotted on separate axes.

Regards,
John

0 Aidan Walton over 6 years ago in reply to John Miller - Sensing

Expert 1095 points

Thanks again John, once again I realised this a little later. :) Sorry. Learning curve!

0 John Miller - Sensing over 6 years ago in reply to Aidan Walton

TI__Mastermind 35495 points

No problem Aidan. If you have any more questions, please let us know.
We are here to help.
John

Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

TINA/Spice: Remember diagram settings does not seem to work