Required controller device to drive the KHLVA-101-5-P

pooja ak

Prodigy 210 points

Other Parts Discussed in Thread: DRV8876, DRV8874EVM

We have planned to use the KHLVA-101-5-P part in one of our projects

Do you have any controller to drive this device?

For your reference below i shared the link for KHLVA-101-5-P part

https://www.omega.com/en-us/industrial-heaters/surface-heaters/flexible-heaters/khra-khlva-kha-series/p/KHLVA-101-5-P

Requesting you to helps us on this.

Thanks,

Pooja Ak

over 3 years ago

0 Ryan Kehr over 3 years ago

TI__Guru 55755 points

Hello,

I think any of these devices would work as they are basically h-bridges. Depends on your current and voltage needs.

https://www.ti.com/motor-drivers/brushed-dc-bdc-drivers/overview.html

Regards,

Ryan

0 pooja ak over 3 years ago in reply to Ryan Kehr

Prodigy 210 points

Helo Ryan,

sorry for the delay,

will use the heater in medical (lab) .

here by I attached the driver requirement .

1)Drivers shall be developed to provide PWM output at 24V DC (~4W) to heater film On PID constants is defined by the end user.

2) driver should support on software control to alter P, I, and D constants and set points

requesting you to helps us on this

Thanks,

Pooja Ak

+1 Ryan Kehr over 3 years ago in reply to pooja ak

TI__Guru 55755 points

Hello,

We don't have anything will integrated PID control. This would need to be done in a companion MCU chip to our driver.

Regards,

Ryan

0 pooja ak over 3 years ago in reply to Ryan Kehr

Prodigy 210 points

Dear Ryan,

Can you suggest a MCU which will supports to our requirement

Thanks,

Pooja Ak

0 Ryan Kehr over 3 years ago in reply to pooja ak

TI__Guru 55755 points

Pooja,

Please check the DRV8876 or DRV8874EVM, that MCU should be sufficient.

Regards,

Ryan

0 pooja ak over 3 years ago in reply to Ryan Kehr

Prodigy 210 points

Dear Ryan,

Thanks for the support,
I have some query's on suggested part!

Suggested part application is different and our application is different,

Driver which needs to drive the Flexible polyamide driver
if iam wrong, please correct me.

Thanks,

PoojaAk

0 Ryan Kehr over 3 years ago in reply to pooja ak

TI__Guru 55755 points

Pooja,

It appears we have multiple threads going on this topic.

https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1180102/required-ic-or-driver-to-drive-https-www-omega-com-en-us-industrial-heaters-surface-heaters-flexible-heaters-khra-khlva-kha-series-p-khlva-101-5-p-part

Let's keep the conversation going on the thread above please.

We are not experts in driving the load you are using. All I can recommend are standard H-bridges that can be used to control current. The loop would have to be closed outside of our chip and I can't help you with that. We have recommended devices and micro-controllers. That is the best we can do.

Regards,

Ryan

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

Required controller device to drive the KHLVA-101-5-P