WEBENCH® Tools: Simulation, hardware & system design tools forum

Filipe Rubinstein

Tool/software: WEBENCH® Design Tools

Hi all,

It appears that the DCR values for the IHLP6767DZER/GZER are incorrect are Webench. Please refer to the below pictures for specific information. Thank you in advance for looking at this and I hope the issue is resolved soon!

over 5 years ago

0 Umayal Ramanathan over 5 years ago

TI__Expert 5550 points

Hi Filipe,

Thanks for contacting us.I am unable to view shared design.

Could you please re-share the design ?

Thanks and Regards,

Umayal

0 Filipe Rubinstein over 5 years ago in reply to Umayal Ramanathan

TI__Intellectual 831 points

Hi Umayal, I apologize for the technical difficulties. Attached should be the actual pictures.

0 Umayal Ramanathan over 5 years ago in reply to Filipe Rubinstein

TI__Expert 5550 points

Hi Filipe,

Thanks for sharing the pictures replicating the issue.

We shall correct the inductor DCR value as per datasheet and keep you updated on the fix.

Regards,

Umayal

0 Umayal Ramanathan over 5 years ago in reply to Umayal Ramanathan

TI__Expert 5550 points

Hi Filipe,

We have fixed this issue.The fix will be available on ti.com in our next release cycle (tentatively by mid August). Kindly let us know in case of any queries.

Thanks and Regards,

Umayal